DIY Push-Pull Car Subwoofer Boxes Design Speaker

November 4, 2011 diy, speaker, subwoofer

DIY Push-Pull Car Subwoofer Boxes Design Speaker

Subwoofer designs vary to produce different sounds. You can do it, DIY push-pull car subwoofer boxes design speaker. For the consumer do-it-yourself who loves music, press the Speaker subwoofer design provides a means to their favorite songs in a way that does not listen to another product design speaker. Its body design is quite different from a loudspeaker housing two closed regular speakers, its basic structure has two sides, a top and bottom and front and back ways. The distinction is that the sound is different, the way the speakers are installed.

Measure to determine the diameter of the speaker and add 6 inches, the length of the cabinet. Add 4 inches to the height of the cabinet received. Cut four pieces with a table saw to the dimensions of the MDF. These are the front, rear, top and bottom of the cabinet.

Determine the radius of the speakers and add 2 inches. Measure from the narrow side of one of the pieces and make a mark. Divide the measurement height of 2 and a marker on the previous mark. The point where the tracks intersect is the center of the enclosure.

Set your compass to measure the radius of the speakers. Place the point of the compass to the point where the cut marks and draw a circle. Repeat for the other brands.

Drill a 3 / 8 inch circles and cut out circles with a jigsaw. Mount the top, bottom, front and back with screws.

Measure the inside of the Assembly at the ends and cut two pieces of MDF. Add them to the ends of the enclosure and secure with screws.

Joints in wood with silicone sealant. Lay the case, it shows the front side. Make holes in the back for connection of the cut.

Connect the cut of the terminal and install it on the back of the case. Connect the cable to the speakers and install, with the magnet inside the housing and the other with the magnet outside the car subwoofer cabinet.